Visibility 40 m

Built to hold.

Nine pieces of alpine clothing, designed and repaired in Lecco and tested from the Grigne to Val Masino. When one tears, we mend it — free, for ten years.

sosta /ˈsɔs.ta/ · n. f. · Italian

The belay stance at the top of a pitch: the one place on a climb that has to hold. We make clothing the same way — few pieces, each one tested on the rock and mended on our bench when it tears, not replaced.

520 g
The Arête Shell in size M, weighed on our own scale with every zip and cord attached.
10 years
Free repairs on our bench in Lecco. After that, at cost.
PFAS-free
Made without intentionally added PFAS: fabric, membrane, finish, seam tape and zips. Every batch tested below 50 ppm total fluorine.

The system

Nine pieces that layer into one another. No two do the same job, and we add a new one only when it replaces two.

Move warm, stop warmer.

What we wear, and what rides in the pack, from the car park to the hut and up the route. The down stays at the hut; nothing comes off at the belay: the parka goes on over everything.

What the system leaves out: waterproof shell trousers, an active-insulation jacket, long johns and a warm mitt for long belays. Good ones exist, and we add a tenth piece only when it replaces two.

Which pieces are worn and which are carried in five situations

WornIn the packLeft at the hut

The same Arête Shell after nine seasons: faded, with patches on the forearm and the hip and a new cuff tab.

No. AR-0117

One shell, nine seasons.

Arête Shell no. AR-0117 left Lecco in October 2016, a first-generation Arête with a polyurethane membrane. Today’s is made with ePE on the same pattern, so every part still fits it. It has been back to our bench four times. This is its record.

Season
1/ 9
Days out
0
Repairs
0
Paid
€0

    Ten years of free repairs, then at cost. Spare parts — sliders, cord locks, cuff tabs — sent free for as long as you own the piece. How repairs work

    Hands guide an orange shell jacket under an industrial sewing machine in the Lecco workshop, a roll of seam tape and offcuts on the table, the lake outside the window.

    The repair bench is twelve metres from the cutting table.

    The people who sew your jacket are the people who mend it. Send it back in the bag it came in: most repairs take under an hour on the bench and are back with you within two weeks.

    Start a repair

    Field notes

    Where the nine pieces are tested: the limestone of the Grigne above Lecco and the granite of Val Masino.

    How we build

    1. Weights we measured

      Every weight on this site is size M (gloves: a pair, size 9; beanie: S/M), on our own scale, with every zip, cord and tab attached. No “from” figures.

    2. Wear zones are panels

      Shoulders, forearms and inner ankles are separate panels. When one wears out, we sew in a new one and the jacket goes back on the hill.

    3. One set of parts

      The same zips, sliders, cord locks and cuff tabs across the range, kept in stock for every piece we have ever sold.

    4. PFAS-free since 2014

      Our first jacket had a fluorine-free finish in 2014, twelve years before France banned PFAS in clothing. A fluorine-free finish wears off sooner: re-proof when water stops beading on the shoulders.

    Added to your bag